1-519-884-5545        Contact Us        Sign in

Spare Parts

Find products such as Replacement Drives, Lasers, cooler fans, Xecuter LT Clip and Switch V2 and other Cables in this category. Click on desired product to view further product information.

Products


  • XBox 360 Slim Unlock Kit

    A case opening kit for Xbox 360 Slim, using the best steel for molding, specially designed for unlocking the Xbox 360 Slim console.

    $6.95 (US $6.95)
    $9.99 , save 30%
  • XCM High Speed Air Cooler v2.0

    Monitor the temperature on the GPU and CPU of your XBox 360. If it gets too hot, this and the fan can make it cooler by adjusting a setting.

    $59.95 (US $59.95)
     
  • Xecuter CK3 Extended Power Cable

    This extended power cable can be used with the CK3 Pro or CK3 Lite as an easy way to give yourself much extra room when working with your drives. The cables are high quality and nicely shrink wrapped to make everything as neat and secure as possible.

    The CK3 Extended Power Cable is is 18 inches in length. This cable is for the CK3 Pro or CK3 Lite only, and supports the Mini probe, probe v1, Probe v2. This cable does not support Probe v3.

    $5.95 (US $5.95)
    $12.95 , save 54%
  • Xecuter LT Switch 1.5

    Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an ON/OFF Led to show correct operation when switching to 0x72 vendor mode. Now Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor - but required an 18 Ohm or 22 Ohm resistor - so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms - this will work 99% of the time)

    $2.95 (US $2.95)
    $9.99 , save 70%
  • Xecuter LT Switch v1.6

    This is the new 4 position resistor - 4th value details will be added shortly.

    This is the new Xecuter LT Switch v1.6 - the latest version in the #1 selling Xecuter LT Switch range.
    Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an ON/OFF Led to show correct operation when switching to 0x72 vendor mode.
    Now Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor - but required an 18 Ohm or 22 Ohm resistor - so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms - this will work 99% of the time)

    The installation is very simple and takes about 5 minutes if you have some small experience with a soldering iron. It has been tested with the latest Jungle Flasher 0.1.73. All Liteon drive versions have been tested with 100% Success (Including the troublesome Winbond IC). There is no need to remove the LT Switch after it has been installed - simply switch to normal mode and you are good to go. Even if you have to upgrade in the future - you don't have to touch the switch again !
    Don't be fooled by more expensive copycat products. This is the only solution you need to do a very simple job. Remember this product follows the K.I.S.S engineering principle (KEEP IT SIMPLE STUPID) :)
    The Only Liteon Solution Recommended By Team Jungle !
    Enables Read/Write on ALL Liteon 74850, 83850, 93450 DVD Drives
    Easy & Simple Install - Install Once & Forget
    Enable / Disable Switch
    Multi-R Switch (18, 20, 22 Ohms)
    On/Off LED
    Completely Undetectable
    No Need To Uninstall
    Works with ALL tools including the latest Jungle Flasher


    This device is designed primarily to aid or assist in the repair or replacement of defective hardware and also for the use of and development of legal open source software. It does not enable any kind of piracy or have any code whatsoever that circumvents any kind of protection. We do not support nor encourage, if possible, potential infringements of others intellectual property rights - please do not contact us with any question related to this use as we will not respond. DO NOT use or buy this product if you are looking to perform any illegal activity.

    $5.95 (US $5.95)
    $6.99 , save 15%
  • Xecuter USB to Molex 5V Power Cable

    New from Team Xecuter. Ever needed fast molex power and you can't get your hands on a power supply ?

    This handy cable provides a full 5V from your USB port to a Molex connector giving you full power to be able to update the firmware on your 360 DVD Drive.

    You can get the essential 5V supply for your 360 DVD Drive, the only thing you wont get is the 12V line for eject. Eject is only required when performing certain recovery procedures, but for the most part all you will ever need is the 5V - a great cable thats useful in any modders toolkit.

     

    $4.95 (US $4.95)
    $4.99 , save 1%


Categories

Manufacturers