--> INSTALLATION GUIDE <--
Xeno GC is a low cost easy solder (no wires) modchip for GameCube. This chip have a unique hardware design which directly interfaces with the serial debugport on the laser unit.......
The XenoGC features two status LEDs to indicate correct function. The red LED is active when the drive resets and the chip is doing its job. Once the drive has been patched successfully, the green LED will light up. Check your install if you only get the red LED, or it doesnt light up at all.
4 ohms: 75 watts RMS per channel 8 ohms: 45 watts RMS per channel 8 ohms: 150 watts RMS, bridged mode 10Hz - 70kHz +0, -3dB < 0.02% @ 4ohms, 20Hz - 20kHz +4dB for rated output -85dB, 1kHz +/- 50 mV, Servo controlled