You never have to solder/unsolder the trace cut again!
At the moment when using a Sputnik Probe you have to repair the trace when you have finished programming, and if you ever need to flash the drive again you would have to de-solder.
This simple PCB addon enables you to solder the board once and then thats all you will ever need to do. The simple switch will open / close the circuit and there is an extra large pad to use when probing for when you need to unlock the SPI.
This is a 1GBIT NAND PCB Add-on for the PROGSKEET programmer. Allows Dual Nand features allowing multiple scenarios and uses for consoles with 128MB NAND onboard flash memory
Uses 2 x 32 pin ZIF sockets on each side of the PCB so requires the PROGSKEET Adaptor PCB Kit