Xecuter Sputnik 360 Liteon DG-16D4S Unlock Switch

IN STOCK

 

Replace your Xbox 360 DVD Drive if you are experiencing the following problems with your XBOX 360 Slim:

1. Disc read errors
2. Slow loading times
3. Failure to read disc
4. Screen freezes when playing a game or watching a DVD movie

These are genuine replacement drives removed from other XBox 360 SLIM consoles by the manufacturer.

Tested at our supplier's facility and are fully functional.

You will need to flash your drive key onto this board to make your drive work with your for Xbox 360 SLIM. Or swap the logic board.

• The drive is ready to be flashed and/or dumped with the appropriate tools.
• 100% compatible with all XBox 360 SLIM consoles
• Application of single/double-sided, single/dual layer DVD-5/9's
• Support for DVD-R/RW, DVD-RAM

Contents:

• 1x Lite-On DG-16D4S DVD Drive

IN STOCK

COMPATIBILITY:

• LITEON DG-16D4S: YES
• LITEON DG-16D5S: YES
• HITACHI DL10N: NO

You should replace your laser lens if your system has the following problems:

• "Disc Read Errors" message or disc appears damaged or dirty on the screen.
• System reads certain games or movies.
• System loads games or movies longer than normal.
• System reads games or movies and seems to be freezing or skipping

IN STOCK

Never solder/unsolder the trace cut again!

When using a Sputnik Probe you have to repair the trace when you have finished programming, and if you ever need to flash the drive again you would have to de-solder.

This simple PCB add-on enables you to solder the board once and then thats all you will ever need to do. The simple switch will open / close the circuit and there is an extra large pad to use when probing for when you need to unlock the SPI.

Open / Close trace cut without further soldering
Large pad for easy probing
Easy to install - takes minutes!

NOTE: This is NOT the SPUTNIK360 - Liteon DG-16D4S DVD Unlock Switch, this is an addon product for the SPUTNIK360 PROBE and will not unlock the SPI without the use of the Probe.

This device is designed primarily to aid or assist in the repair or replacement of defective hardware. It does not enable any kind of piracy or have any code or any kind of microchip whatsoever that circumvents any kind of protection. It is a basic circuit of wires and diodes that is all. We do not support nor encourage, if possible, potential infringements of others intellectual property rights - please do not contact us with any question related to this use as we will not respond. DO NOT use or buy this product if you are looking to perform any illegal activity.

Team Maximus releases the Stinger 3.0L to RGH your XBox360 PHAT and SLIM (Trinity)

Fast RGH 2 glitcher chip.

New Model 3.0L (with crystal for Corona compatibility) PAD by PAD compatible with last Stinger 2.0, it uses same .jed or .xsvf files, the improvement are:

• Super easy install on Slim Consoles (if used with the new QSB Kit 2.0)
• Ultra fast boot times for SLIM Consoles
• Embedded capacitor for stubborn PHAT consoles

To use the 68nf capacitor for stubborn PHAT consoles just bridge the J68NF jumper and add a Ground wire on the AVG pad to the AV port.

Features:

• Clean and optimized design
• Low digital noise
• Onboard voltage regulations for 1.8v and 1.5v for a stable operation.
• Less solder, 5 points for SLIM, 6 for PHAT
• Less complication for PHAT models having Mode switch instead of having to reprogram for each model
• Ultra fast boot times for PHAT and SLIM in less than 10 secs with or without latest Ameel "long wire trick"
• Comes with programming cable (not a programmer)
• Can be programmed with NandFlasher updated to Nandpro 3.0 or any JTAG programmer available

Contents:

• Maximus Stinger v3.0L
• Ground Cable
• Programming Cable

The SLIM program works on all TRINITY boards.

The PHAT program works on all HDMI models (Falcon, Zephyr, Jasper), and once programmed the model is chosen by setting the onboard solder jumpers.

Chips can be reprogrammed using NANDFLASHER (updated to nandpro 3.0) or any JTAG cable.

Hardware is the same for PHAT and SLIM. It is only the on-board program which can of course be changed later by the end user if needed.

Support:

http://360nandflasher.com

PlayStation 2 Cover Pack ! Protect your PlayStation2 console in/out ports against dust and dirt. The pack includes protectors for 2 controller ports, both USB ports, the S400 port, Multi AV out as well as the AC power plug port.