Beware of clones! Only buy from authorized resellers!
NOTE: THESE WORK GREAT FOR PHAT 360 CONSOLES! OUR TECH HAS TESTED THEM AND FOUND THEM TO BE THE BEST PERFORMANCE.
NOTE: The Mtx Glitcher ships with empty CPLD, it needs programming via JTAG. The Matrix NAND Programmer WILL NOT work to program the Matrix Glitcher, it is strictly for the NAND flash located on the Xbox 360 motherboard.
For matrix glitcher you need the jrp v2 (order from the drop down menu)
You need to solder directly to the chip and run wires from the jrp v2
Please use the rgh2 glitch hack diagram
The Matrix Glitcher 360 features a xilinx cpld with on board voltage switch for phat consoles and a built-in jtag port to ensure current and future compatibility with the "GliGLi hack" implementation.
A pdf with the complete procedure to implement the GliGli Hack (made by Razkar and Tuxuser) as well as all the needed files are mirrored in the download section found here.
• Booting of unsigned code on Xbox 360
• Compatible with both X360 (except Xenon)
• Works with all X360 NAND programmers
• Compatible with all X360 kernel versions
• Quick installation (7 Wires on Slim or 6 Wires on Phat)
• Compact PCB size with easy to solder pads.
• Booting of X360 unsigned code within max of 2 minutes
• Matrix Design and Quality
• Budget pricing
Matrix NAND Programmer – (Release date 8 September 2011)
Cost effective NAND reader / programmer to complete the GliGli Hack..
• Fast USB SPI 360 NAND programmer!
Perfect for increasing RGH boot time of Big Block Jaspers (256/512) and other problematic Phat Xbox's.
Quality ceramic coating guarantees high moisture resistance and a wide operating temperature range. Operating tolerance ± 10%.
0.068uF / 68nF Rating.
Allen & Heath Zone 62 Club Mixer Technical Specifications 0dBu = 0.775 Volts rms +4dBu = 1.23V rms 0dBV = 1 Volt rms -10dBV = 316mV rms Maximum output level XLR +26dBu into >2k ohm load TRS jack +21dBu into >2k ohm load RCA Phono +15dBu into >10K ohm load Internal headroom Channels +21dB Mix to output +23dB Peak indicators Turn on 5dB before clipping Meters MIX /MONITOR Peak hold 12 LED 3 colour STEREO CHANNEL Peak reading 4 LED 3 colour Frequency response 20Hz to 40kHz +0/-1dB Distortion THD+noise measured at +14dBu 1kHz < 0.006% Crosstalk channel shutoff measured at 1kHz < 90dB Noise measured rms 22Hz to 22kHz MIC EIN -128dB referred to 150 ohm source Residual output noise XLR -90dBu (-94dB S/N) TRS jack -84dBu (-84dB S/N) L RCA -92dBu (-84dB S/N) Mix noise, ch routed XLR -86dBu (-90dB S/N) TRS jack -82dBu (-82dB S/N) RCA Phono -91dBu (-83dB S/N) Power Supply Internal switch mode power unit with auto sensing mains input. MAINS IN socket IEC 3 pin Power lead Country dependent with moulded mains plug supplied AC mains 100 to 240V AC @ 50/60Hz Consumption 30W max Mains fuse rating 100-240V AC T500mA 20mm