Never solder/unsolder the trace cut again!
When using a Sputnik Probe you have to repair the trace when you have finished programming, and if you ever need to flash the drive again you would have to de-solder.
This simple PCB add-on enables you to solder the board once and then thats all you will ever need to do. The simple switch will open / close the circuit and there is an extra large pad to use when probing for when you need to unlock the SPI.
Open / Close trace cut without further soldering
Large pad for easy probing
Easy to install - takes minutes!
NOTE: This is NOT the SPUTNIK360 - Liteon DG-16D4S DVD Unlock Switch, this is an addon product for the SPUTNIK360 PROBE and will not unlock the SPI without the use of the Probe.
This device is designed primarily to aid or assist in the repair or replacement of defective hardware. It does not enable any kind of piracy or have any code or any kind of microchip whatsoever that circumvents any kind of protection. It is a basic circuit of wires and diodes that is all. We do not support nor encourage, if possible, potential infringements of others intellectual property rights - please do not contact us with any question related to this use as we will not respond. DO NOT use or buy this product if you are looking to perform any illegal activity.
The SPUTNIK360 is a simple device that disables the write protect on any Liteon DG-16D4S drive that has the MXIC SPI flash device so you can easily repair or replace your faulty DVD drive with this model and have the ability to program your consoles DVD key.
Yet another simple and useful device from Team Xecuter.