Metal Gears MG996R 13kg Servo Motor with Accessories kit. Compliant with most standard receiver connector: Futaba, Hitec, Sanwa, GWS etc. Great for Truck, Boat, Racing Car, Helicopter and Airplane.
The PIC18F4550 USB Dev Kit is loaded with features, including a large 32kb of program memory, optimized for C programs. The PIC18F4550 Development Board comes complete with the Microchip PIC18F4550 microcontroller pre-installed, together with the necessary crystal and power supply components, for a ready-to-run solution. Simply connect the power and download your program, using the easy to use programming interface and software, and your ready to start exploring the new PIC18 USB.
PIC18F USB Dev Kit Programs can be downloaded or updated directly to the microcontroller using the USB in-circuit programming interface together with a suitable programmer or MPLabs HID Bootloader software.
Now works with v3 Heremes!
Pushbuttons and LED's are also included on our development board for testing and developing your code. This board is the ideal for applications requiring a USB Connection together with a large number of A/D inputs for monitoring and control.
Our new PIC18F4550 Development board will get you started with an inexpensive, ready-to-run solution, which is ideal for the student or hobbyist.
Tired of your slim PS3 wasting electricity in standby mode? We designed a simple AC cable to allow you to turn the console power off so you dont waste dollars in electricity your not using.
The Raspberry Pi Zero is half the size of a Model A+, with twice the utility. A tiny Raspberry Pi that’s affordable enough for any project!
NOTE: RASPBERRY PI ZERO CASE INCLUDED!
UPDATE: TEAM E3 HAS REPLACED THE ORIGINAL ESATA DOCKING STATION WITH A NEW ESATA HDD ADAPTER WITH SMALLER FORM FACTOR. AS OF 5.20.14 YOU RECEIVE THESE IN SMALLER PACKAGING FROM THE E3 TEAM!
ALL E3 Flashers Kits are sold with European power supply adapters. Power conversion adapters for US/Canada power sold separately.
If you are outside North America, shipping may be slightly more than as shown on our website due to the weight of the E3 Flasher being 3lbs. You will be contacted to pay for additional shipping.
You will also need a downgrade dongle such as the E3 Card Reader AVR to perform the downgrade.
Warning. This product is not 'hard' to install, but is very easy for you to stuff up your console. There is no warranty on the clip device. You have 1 shot to get it onto the console. If you apply the clip wrong you will get a bad read, and the pins on the clip will be damaged.
Please note that you have to make sure the clip is perfectly flush with the motherboard before you press it down. The majority of the issues lie with improper installation of the clip. If the clip is uneven before you press it down, it will slightly bend the pins on the bottom of the clip.
This Ultimate PS3 Downgrade Device - will allow you to downgrade a NOR PS3 from any new firmare to 3.55!
This device is only for consoles with NOR flash, not NAND at the moment. (Doesn't work on Slim 3000 or superslim consoles)
Here is a great installation video:
These are the pre-packaged contents for the E3 Flasher complete kit. If you see resellers/distributors selling for less, it's because they are not selling the package with everything seen below.
NOTE: NEW E3 ESATA DOCKING STATION REPLACED BY SMALLER E3 ESATA USB HDD ADAPTER!
This device will require you to simply open up your SLIM PS3 to take the HD out and solder. For the FAT PS3 you WILL require soldering! As well, the plug that they include with the sata dock is not North American.
Please double check to make sure it works with your PS3 as we will not issue refunds if it is not compatible with your PS3 after it has been installed.
Watch the Official E3DIY Video:
Great For The Gamer On The Go!