Allen & Heath Zone 62 Club Mixer Technical Specifications 0dBu = 0.775 Volts rms +4dBu = 1.23V rms 0dBV = 1 Volt rms -10dBV = 316mV rms Maximum output level XLR +26dBu into >2k ohm load TRS jack +21dBu into >2k ohm load RCA Phono +15dBu into >10K ohm load Internal headroom Channels +21dB Mix to output +23dB Peak indicators Turn on 5dB before clipping Meters MIX /MONITOR Peak hold 12 LED 3 colour STEREO CHANNEL Peak reading 4 LED 3 colour Frequency response 20Hz to 40kHz +0/-1dB Distortion THD+noise measured at +14dBu 1kHz < 0.006% Crosstalk channel shutoff measured at 1kHz < 90dB Noise measured rms 22Hz to 22kHz MIC EIN -128dB referred to 150 ohm source Residual output noise XLR -90dBu (-94dB S/N) TRS jack -84dBu (-84dB S/N) L RCA -92dBu (-84dB S/N) Mix noise, ch routed XLR -86dBu (-90dB S/N) TRS jack -82dBu (-82dB S/N) RCA Phono -91dBu (-83dB S/N) Power Supply Internal switch mode power unit with auto sensing mains input. MAINS IN socket IEC 3 pin Power lead Country dependent with moulded mains plug supplied AC mains 100 to 240V AC @ 50/60Hz Consumption 30W max Mains fuse rating 100-240V AC T500mA 20mm
Already comes with the E3 ODE complete version. Great for replacing your damaged E3 ODE QSB from a bad installation!
Kingston 32GB Class 4 MicroSD Memory Card w/ FREE SDHC Adapter
SDHC cards offer larger volume data storage and optimized recording performance with support for FAT 32 file formats. In addition, Kingston's SDHC cards use new speed class ratings known as Class 2, 4 and 6 that deliver a minimum data transfer rate for optimum performance with SDHC devices.
Although identical in size to todays standard SD card, the new SDHC cards are designed differently and are only recognized by SDHC host devices. To ensure compatibility, look for the SDHC logo on cards and host devices (cameras, camcorders, etc.).
For added reliability and durability, Kingston's solid-state SDHC memory cards are built of nonvolatile memory components and have no moving parts that could wear out or break. All cards are 100-percent tested by the manufacturer.
Please check compatibility before you purchase.
PS Vita 3G to microSD card adapter v2.1
NOTE: NO NEED TO SOLDER THE JUMPER WIRE, THESE ARE WORKING 100%
NOTE: NEW INSTRUCTIONS AND NEW SOFTWARE FOR DOWNLOAD:
modify ur0:tai/config.txt and add ur0:tai/usbmc.skprx under the line that says *KERNEL.
Also copy usbmc.skprx under ur0:tai.
Copy the Enso.vpk, usbmc_installer, vitashell.vpk to UX0: apps
2. Install usbmc_installer
3. Click usbmc_installer bubble , install and then
4. Go back usbmc_installer, press cross and then square
After reboot, you can see the sd card
References YouTube link: