NOTE: due to ceased production, we cannot re-stock these. Once they're gone, they're gone.
Do you have a faulty Liteon DG-16D4S DVD in your Xbox 360 ? Are you swapping your drive to another console and are unable to program your firmware due to write protection being enabled ?
Team Xecuter have done it again with these replacement PCB's. Fits all Liteon DG-16D4S drive versions and allows you to reprogram your firmware to the board and then to set it to write protect to secure against any accidental firmware corruption / erasing.
Due to popular demand, version 1.1 of the PCB has been redesigned to have the unlock switch external to the DVD drive. This allows you to program the board without the hassle of dissassembling the drive any longer!
Note: All replacement boards are shipped blank. You must program your consoles correct firmware version and drive key. Easy instructions can be found as always on the Xecuter Support Forums
NOTE: This device is designed primarily to aid or assist in the repair or replacement of defective hardware. It does not enable any kind of piracy or have any code or any kind of microchip whatsoever that circumvents any kind of protection. It is a basic circuit of wires and diodes that is all. We do not support nor encourage, if possible, potential infringements of others intellectual property rights - please do not contact us with any question related to this use as we will not respond. DO NOT use or buy this product if you are looking to perform any illegal activity
4 ohms: 75 watts RMS per channel 8 ohms: 45 watts RMS per channel 8 ohms: 150 watts RMS, bridged mode 10Hz - 70kHz +0, -3dB < 0.02% @ 4ohms, 20Hz - 20kHz +4dB for rated output -85dB, 1kHz +/- 50 mV, Servo controlled