Is your old Hitachi/Samsung/Benq System on its last legs ? Overheating and Freezing Issues ? 2 x Red Lights Crashing Your System ? THE ULTIMATE SOLUTION IS HERE !!!!!!
The Xecuter xDrive Plus (inc xFan) is the next level in Xbox 360 cooling, stability and easy external firmware upgrading. The famous Team Xecuter have once again developed a solution to a very common problem on the older Xbox 360 consoles - the dreaded 2 x Red Lights and Overheating / Game Freezing issues.
Using the same technology as used on the original xDrive, you now have the ability to remove your internal 360 DVD ROM and have it connected to your 360 externally. The space where your internal DVD used to be is then replaced by an entire cooling system - as this is one of the main sources of heat inside the Xbox and it resides directly over the GPU (which is the main causes of overheating issues / game freezing / graphics corruption / rrod) - this now gives your Xbox a drop in temperature that is unprecedented in any of the cooling kits or fans that have ever been released before. In tests the GPU alone dropped as much as 20 Degrees Celsius with the xFan enabled !!! The entire system is completely custom designed from the ground up. It has been extensively tested by many users on the Xecuter forums and has shown to be a resounding success. One user reported that his console would give 2 Red Lights (Over heated) after 5 minutes even with the RROD Repair Kit installed and also with a Whisper Legacy Fan. When he installed the xDrive Plus and xFan - he tested the system overnight and finally turned it off manually after it had been running game demos for 20 hours straight !!! AMAZING RESULTS !!!
As a bonus your 360 DVD drive is now completely external to your Xbox so you can simply connected the xDrive to a CK3 and SATA cable and update your firmware (There is a CK3 port and SATA port built in to the read of the xDrive for your convenience) You may also want a second drive to perform backups of your valuable Xbox 360 games using the special 0800 firmware. It's a very simple case of Plug 'n Play.
Click Here to see the huge changes in temperature when the xFan is activated !!!
Allen & Heath Zone 62 Club Mixer Technical Specifications 0dBu = 0.775 Volts rms +4dBu = 1.23V rms 0dBV = 1 Volt rms -10dBV = 316mV rms Maximum output level XLR +26dBu into >2k ohm load TRS jack +21dBu into >2k ohm load RCA Phono +15dBu into >10K ohm load Internal headroom Channels +21dB Mix to output +23dB Peak indicators Turn on 5dB before clipping Meters MIX /MONITOR Peak hold 12 LED 3 colour STEREO CHANNEL Peak reading 4 LED 3 colour Frequency response 20Hz to 40kHz +0/-1dB Distortion THD+noise measured at +14dBu 1kHz < 0.006% Crosstalk channel shutoff measured at 1kHz < 90dB Noise measured rms 22Hz to 22kHz MIC EIN -128dB referred to 150 ohm source Residual output noise XLR -90dBu (-94dB S/N) TRS jack -84dBu (-84dB S/N) L RCA -92dBu (-84dB S/N) Mix noise, ch routed XLR -86dBu (-90dB S/N) TRS jack -82dBu (-82dB S/N) RCA Phono -91dBu (-83dB S/N) Power Supply Internal switch mode power unit with auto sensing mains input. MAINS IN socket IEC 3 pin Power lead Country dependent with moulded mains plug supplied AC mains 100 to 240V AC @ 50/60Hz Consumption 30W max Mains fuse rating 100-240V AC T500mA 20mm